Every pierce causes wear – electrode, nozzle, shield cap, protective glass – regardless of how far you cut afterwards. Until now, that share could only be folded into the cutting metre rate. On nests with many small internal contours this leads to under-calculation, and on long cuts with few contours to over-calculation.
That is why OmniWin 2026 records piercing costs separately – for all cutting processes. Your calculation follows actual wear instead of an average, and every quotation reflects the contour count of the job in front of you.
Cost and time calculation that matches the part, not the mean value.
Would you like to see OmniWin 2026 in action? Visit Messer Cutting Systems at EuroBLECH 2026 from 20 to 23 October in Hanover and at FABTECH 2026 from 21 to 23 October in the Central Hall of the Las Vegas Convention Center, Booth C4616.